Honda Fit: Immobilizer-Keyless Control Unit Replacement
NOTE: SRS components are located in the area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing.
-
Remove the steering column covers.
-
Disconnect the 7P connector (A) from the immobilizer-keyless control unit (B).
-
Remove the two screws and the immobilizer-keyless control unit.
-
Install the immobilizer-keyless control unit in the reverse order of removal.
-
After replacement, register the immobilizer-keyless control unit (all of the customer's keys are required), and make sure the immobilizer system works properly.
See also:
Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshie ...
Lift and Support Points
NOTE: If you are going to remove heavy components such as suspension or the fuel
tank from the rear of the vehicle, first support the front of the vehicle with tall
safety stands. When substantial ...
Warm Up TWC Removal/Installation
NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC
for debris.
Raise the vehicle on a lift.
Remove the bolts (A).
Lower the vehicle.
...
Categories
