Honda Fit: Cargo Area Light Test/Replacement
-
Open the tailgate.
-
Carefully pry out the cargo area light (A).
Cargo Area Light:
5 W
-
Disconnect the 2P connector (B) from the cargo area light.
-
Check for continuity between terminals No. 1 (+) and No. 2 (-). There should be continuity. If there is no continuity, check the bulb. If the bulb is OK, replace the cargo area light assembly.
-
Install the light in the reverse order of removal.
See also:
Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe
flange (C) from the end cover (D).
Install a new O-ring (E) over the 3rd clutch feed pipe.
In ...
Intermediate Shaft Removal (A/T)
Drain the transmission fluid. Reinstall the drain plug with a new sealing
washer.
Remove the right driveshaft.
Remove the shift cable cover (A).
Re ...
Front Lower Arm Removal/Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
Do not remove the lower arm from both sides a ...
Categories
