Honda Fit manuals

Honda Fit: Tailgate Spoiler Replacement

Special Tools Required

For Some Models

NOTE:

  1. Pry up at the notches (A) with a flat-tip screwdriver wrapped with protective tape to release the hooks (B), then remove the lids (C) from both sides.

  2. Fastener Locations: Bolt, 2CA6 x 1.0 mm9.8 Nح (1.0 kgfح, 7.2 lbfئt)B
  3. Remove the bolts.

  1. Lift up on the tailgate spoiler (A) to detach the pins (B) of the clips from the grommets (C), then remove the spoiler.

  2. Fastener Locations: Clip, 4BCAC
  3. Remove the grommets from the tailgate with snap ring pliers.

  4. If the grommets or the pins are damaged or stress-whitened, replace them. Always replace both the pin and the grommet if either is damaged.

  5. Install the grommets on the pins by pushing them into place.

  6. Install the spoiler in the reverse order of removal, and push the clips into place securely.

See also:

Start-up
The navigation system starts automatically when you turn the ignition to ACCESSORY (I) or ON (II). At start-up, the following Confirmation screen is displayed. 1. Select Change Language. ► ...

Ignition Switch
Manual transmission models WARNING Removing the key from the ignition switch while driving locks the steering. This can cause you to lose control of the vehicle. Remove the key from the ignit ...

Warm Up TWC Removal/Installation
NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC for debris. Raise the vehicle on a lift. Remove the bolts (A). Lower the vehicle. ...

© 2026 Copyright www.hfitinfo.com