Honda Fit: Front Fender Fairing Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the body.
-
Remove the front inner fender as needed.
-
From the wheel arch, remove the clip and the maintenance plug (A).
-
Release the hooks (B) of the front fender fairing (C) from the holes in the front fender, and pull the fender fairing out, then remove it.
-
Install the fender fairing in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Before installing the clips, make sure the hooks (A) of the front fender fairing (B) are installed into the holes (C) in the front fender securely.
-
Push the clip into place securely.
-
See also:
Mainshaft Bearing and Oil Seal Replacement (M/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 37 x 40 mm 07746-0010200
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Adjustable Bearing Puller, ...
HFL Switch Replacement
SRS components are located in this area.
Review the SRS component location, and the
precautions and procedures in the SRS section before
doing repairs or service.
Remove the ...
Steering Angle Sensor Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle ...
Categories
