Honda Fit: Side Defogger Vent Trim Removal/Installation
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Take care not to scratch the dashboard or its related parts.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
The left side defogger vent trim is shown; the right side defogger vent trim is not removable.
-
Insert the appropriate trim tool into the gap underneath the lowest fin on the side defogger vent trim (A), and pull the vent trim up to release the hook (B).
-
Install the portion of the vent trim opposite the hook first, then push down on the trim until the hook securely engages the dashboard.
See also:
Wheel Runout Inspection
Raise and support the vehicle.
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the axial runout by turning
the wheel.
...
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Letters
...
Categories
