Honda Fit: Seat Belt Inspection

Out of Vehicle

For front seat belt retractors with seat belt tensioners, review the SRS component locations   and the precautions and procedures   before doing repairs or service.

Retractor

1. Before installing the retractor, check that the seat belt can be pulled out freely.

2. Make sure that the seat belt does not lock when the retractor (A) is leaned slowly up to 15

   See also:

   Piston Installation
   If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

   A/F Sensor Replacement
   Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Remove the cowl cover   and the under-cowl panel. Disconnect the A/F se ...

   Tailgate Lock Cylinder Replacement
   For Some Models NOTE: Put on gloves to protect your hands. Remove the tailgate lower trim panal. Disconnect the tailgate cylinder rod (A). NOTE: Check for damaged or stress-wh ...