Honda Fit: Steering Gear Assembly

See also:

Block and Piston Inspection
Remove the crankshaft and the pistons. Check the piston for distortion or cracks. Measure the piston skirt diameter (A) at a point 16 mm (0.63 in)   from ...

Breather Line and Suction Line Inspection (Page-1)
Special Tools Required Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150 Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially available Vacuum/Pressure Gauge, 0-4 inHg 07 ...

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...