Measure the resistance between the slip rings (A):
If the resistance is within the standard, go to step 22.
If the resistance is not within the standard, replace the rotor assembly.
Coil (rotor) resistance
|
Standard: |
2.1-2.3 ? at 68 °F (20 °C) |
Check for continuity between each slip ring and the rotor (B) and the rotor shaft (C):
If there is no continuity, replace the rear housing assembly, go to step 23.
If there is continuity, replace the rotor assembly.
Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver Attachment 07947-ZV00100
Remove the oil seal from the torque converter housing.
Install the n ...
Cylinder Head Cover Removal
Remove the intake manifold chamber.
Disconnect the four ignition coil connectors (A).
Remove the harness holder (B) and the breather hose (C).
Remove ...
Handles and Remote Openers
Rear Door Outer Handle Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Put on glove ...