Honda Fit manuals

Honda Fit: Radiator Connecting Pipe Replacement

  1. Drain the engine coolant.

  1. Remove the thermostat housing.

  1. Remove the connecting pipe (A).

  1. Install the connecting pipe with a new O-ring (B).

  2. Install the thermostat housing.

  3. Refill the radiator with engine coolant, and bleed the air from the cooling system.

  4. Clean up any spilled engine coolant.

See also:

Driveshaft Removal
Special Tools Required Ball Joint Remover, 28 mm 07MAC-SL0A202 Ball Joint Thread Protector, 14 mm 071AF-S3VA000 Raise and support the vehicle. Remove the front wheel. ...

Ignition Switch
The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, push it in slightly ...

A/F Sensor Replacement
Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Remove the cowl cover   and the under-cowl panel. Disconnect the A/F se ...

© 2026 Copyright www.hfitinfo.com