Reverse Shift Fork Clearance Inspection (M/T)
Measure the clearance between the reverse idler gear (A) and the reverse
shift fork (B) with a feeler gauge (C). If the clearance is more than the
service limit, go to step 2.
...
Alternator Disassembly (Page -3)
Install a new front bearing in the drive-end housing with a hammer, the driver
handle, 15 x 135L (A), and the bearing driver attachment, 42 x 47 mm (B).
@fo ...
EPS Control Unit Removal/Installation
Do the battery terminal disconnection procedure.
Remove the under-dash fuse/relay box.
Disconnect EPS control unit connector A (11P) and connector B (16P) by
pus ...