Honda Fit manuals

Honda Fit: Maintenance Under the Hood

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Glove Box Striker Replacement
SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. NOTE: Take care not to scra ...

Rear Brake Hose Replacement
Raise and support the vehicle. Remove the rear wheel. Disconnect the brake hose (A) from the brake line (B) using a 10 mm flare-nut wrench (C). ...

© 2026 Copyright www.hfitinfo.com