Specified fluid: Honda Heavy Duty Brake Fluid DOT 3
Use the same fluid for both the brakes and clutch.
NOTICE
Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system and can cause extensive damage.
If the specified brake fluid is not available, you should use only DOT 3 or DOT 4 fluid from a sealed container as a temporary replacement.
Using any non-Honda brake fluid can cause corrosion and decrease the longevity of the system. Have the brake system flushed and refilled with Honda Heavy Duty Brake Fluid DOT 3 as soon as possible.
If the brake fluid level is at or below the MIN mark, have a dealer inspect for leaks or worn brake pads as soon as possible.
The fluid level should be between the MIN and MAX marks on the side of the reservoir.
Manual transmission mo
The fluid level should be between the MIN and MAX marks on the side of the reservoir.
If the clutch fluid level is at or below the MIN mark, have a dealer inspect for leaks or an excessively worn clutch plate as soon as possible.
Clutch Wave-Plate Phase Difference Inspection (A/T)
Place the clutch wave-plate (A) on a surface plate, and set a dial
indicator (B) on the wave-plate.
Find the bottom (C) of a phase difference of the wave-plate, zero the
di ...
Vents, Heating, and A/C
* : If equipped
Airflow Controls
Fan Control Dia
Turn this dial to increase or decrease the fan speed and airflow.
Temperature Control Dial
Turning this dial clockwise increases the temperature ...
Valve Stem-to-Guide Clearance Inspection
Remove the valves.
Subtract the O.D. of the valve stem, measured with a micrometer, from the
I.D. of the valve guide, measured with an inside micrometer or ball gauge.
Take t ...