Honda Fit: Identification Numbers

See also:

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

SRS Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, check for DTCs, for the less obvious deployed components (seat belt tensioners, front impact sensors, side impact sensors, etc). If there is ...

Brightness Control
When the parking lights are turned on and the ignition switch is in ON , you can use the (select/reset) knob to adjust instrument panel brightness. Brighten: Turn the knob to the right. ...